Wednesday, March 23, 2011

Ground Prefabrication Phase I

When the pressure-treated lumber arrived last week, we began to measure and cut pieces of wood to the sizes we needed for the frames for the market ground.
After they were cut, we began to layout the sections of wood we had cut and mark 90 degree angles so that the framing construction would be square.

Once the pieces were lined up, we held them in place as a nail gun was used to connect each joist to the girder on the exterior.

The final product, one market floor frame. These will be used to support the market floor made of locally grown locust wood.

No comments:

Post a Comment